CTX 700 Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter · #1 ·
Hi forum,

I'm still considering buying lift for my bike. If anyone uses with it, please share your experience? I can't understand which is mounting (I mean center) point for this lift and if it is required to remove fairings before lifting?

Any photos are welcome too :)

Thanks,
Mike
 

·
Premium Member
Joined
·
795 Posts
I have a lifting jack I have used on many bikes but I have only used the rear swingarm stand thus far. I have looked under the bike and even had all the lower plastics off but don't see where a good place is to jack. My plan will be to make a wooden frame out of 2x4 wood to go between my jack and the CTX that distributes the weight evenly and lifts both wheels at the same time.. I might bring it out to catch the down tubes where the front footpegs are mounted and then maybe the frame tabs where a center stand can attach. I believe Pit bull makes a stand that also uses these center stand tabs. I just have not had the need yet but not worried about because I have both.
 
1 - 2 of 2 Posts
Top